Doorbell interrupts working.

GPIO cannot do both ADC and ISR so split the pins.

1 files changed, 8 insertions, 7 deletions

diff --git a/main/src/led.c b/main/src/led.c
index 714e0f7..63513f6 100644
--- a/main/src/led.c
+++ b/main/src/led.c
@@ -7,30 +7,31 @@
 #include <led.h>
 #include <intercom.h>
 
+#define LED_ON 1
+#define LED_OFF 0
+
 int intercom_led_identify(hap_acc_t *ha)
 {
     ESP_LOGI(TAG, "Accessory identified");
 
     for (int i = 0; i < 3; i++)
     {
-        gpio_set_level(CONFIG_HOMEKIT_INTERCOM_LED_GPIO_PIN, 1);
+        gpio_set_level(GPIO_NUM_13, LED_ON);
         vTaskDelay(pdMS_TO_TICKS(500));
-        gpio_set_level(CONFIG_HOMEKIT_INTERCOM_LED_GPIO_PIN, 0);
+        gpio_set_level(GPIO_NUM_13, LED_OFF);
         vTaskDelay(pdMS_TO_TICKS(500));
     }
 
     return HAP_SUCCESS;
 }
 
-void intercom_led_init(uint32_t key_gpio_pin)
+void intercom_led_init()
 {
     gpio_config_t io_conf;
-
     io_conf.intr_type = GPIO_INTR_DISABLE;       /* Interrupt for falling edge  */
-    io_conf.pin_bit_mask = 1ULL << key_gpio_pin; /* Bit mask of the pins */
+    io_conf.pin_bit_mask = GPIO_SEL_13;          /* Bit mask of the pins */
     io_conf.mode = GPIO_MODE_OUTPUT;             /* Set as input mode */
     io_conf.pull_up_en = GPIO_PULLUP_DISABLE;    /* Disable internal pull-up */
     io_conf.pull_down_en = GPIO_PULLDOWN_ENABLE; /* Enable internal pull-down */
-
-    gpio_config(&io_conf); /* Set the GPIO configuration */
+    gpio_config(&io_conf);                       /* Set the GPIO configuration */
 }
\ No newline at end of file