---
# RAK6421 WisMesh Pi HAT — RAK13302 (SX1262 + 1W SKY66122 FEM) in SLOT 2.
# Source: meshtastic/firmware bin/config.d/lora-RAK6421-13302-slot2.yaml
repeater_sx1262_bus_id: 0            # spidev0.1
repeater_sx1262_cs_id: 1            # CE1 (BCM 7)
# -1 = hardware CS via spidev. The kernel spi driver owns the CE line, so a
# manual cs_pin here fails with EBUSY; manual CS is only for boards whose NSS
# is wired to a non-CE GPIO (e.g. Waveshare).
repeater_sx1262_cs_pin: -1
repeater_sx1262_reset_pin: 24
repeater_sx1262_busy_pin: 19
repeater_sx1262_irq_pin: 18          # DIO1
repeater_sx1262_use_dio3_tcxo: true
repeater_sx1262_dio3_tcxo_voltage: 1.8
repeater_sx1262_use_dio2_rf: true
# Per upstream's hardware catalog for this board: both SKY66122 FEM enables are
# asserted together via en_pins and DIO2 does the actual TX/RX switching.
repeater_sx1262_txen_pin: -1
repeater_sx1262_rxen_pin: -1
repeater_sx1262_en_pins: [26, 23]
repeater_sx1262_use_gpiod_backend: true
# Upstream's catalog says gpio_chip 1, but on a Pi 4 the 40-pin header is
# gpiochip0 (chip 1 is the 8-line firmware expansion GPIO).
repeater_sx1262_gpio_chip: 0
repeater_sx1262_is_waveshare: false