# Managed by Ansible (openhop/repeater role) — do not edit by hand.

repeater:
  node_name: "{{ repeater_node_name }}"
  latitude: {{ repeater_latitude }}
  longitude: {{ repeater_longitude }}
  identity_file: {{ ('"' + repeater_identity_file + '"') if repeater_identity_file else 'null' }}
  owner_info: "{{ repeater_owner_info }}"
  cache_ttl: 3600
  max_flood_hops: 64
  use_score_for_tx: false
  score_threshold: 0.3
  send_advert_interval_hours: 10
  allow_discovery: true
{% if repeater_admin_password or repeater_jwt_secret %}
  security:
{% if repeater_admin_password %}
    admin_password: "{{ repeater_admin_password }}"
{% endif %}
{% if repeater_jwt_secret %}
    jwt_secret: "{{ repeater_jwt_secret }}"
{% endif %}
{% endif %}

# The daemon defaults its auth DB and telemetry to /var/lib/openhop_repeater
# regardless of other paths, so point it at the role-managed data dir.
storage:
  storage_dir: "{{ repeater_data_dir }}"

radio_type: sx1262

sx1262:
  bus_id: {{ repeater_sx1262_bus_id }}
  cs_id: {{ repeater_sx1262_cs_id }}
  cs_pin: {{ repeater_sx1262_cs_pin }}
  reset_pin: {{ repeater_sx1262_reset_pin }}
  busy_pin: {{ repeater_sx1262_busy_pin }}
  irq_pin: {{ repeater_sx1262_irq_pin }}
  txen_pin: {{ repeater_sx1262_txen_pin }}
  rxen_pin: {{ repeater_sx1262_rxen_pin }}
  en_pins: {{ repeater_sx1262_en_pins | to_json }}
  gpio_chip: {{ repeater_sx1262_gpio_chip }}
  use_gpiod_backend: {{ repeater_sx1262_use_gpiod_backend | string | lower }}
  en_pin: -1
  txled_pin: -1
  rxled_pin: -1
  use_dio3_tcxo: {{ repeater_sx1262_use_dio3_tcxo | string | lower }}
  dio3_tcxo_voltage: {{ repeater_sx1262_dio3_tcxo_voltage }}
  use_dio2_rf: {{ repeater_sx1262_use_dio2_rf | string | lower }}
  is_waveshare: {{ repeater_sx1262_is_waveshare | string | lower }}

radio:
  frequency: {{ repeater_frequency_hz }}
  tx_power: {{ repeater_tx_power_dbm }}
  bandwidth: {{ repeater_bandwidth_hz }}
  spreading_factor: {{ repeater_spreading_factor }}
  coding_rate: {{ repeater_coding_rate }}
  preamble_length: {{ repeater_preamble_length }}
  implicit_header: false

# Observer/telemetry disabled: repeater-only deployment. The daemon enables
# its MQTT pusher whenever an mqtt_brokers/letsmesh/mqtt key is present, even
# with an empty broker list (and then warns on every noise-floor sample), so
# the section must be omitted entirely.

glass:
  enabled: false
  base_url: "http://localhost:8080"
  inform_interval_seconds: 30